THE CHALLENGE
Data centers run their cooling plant continuously, every hour of every day. That relentless duty cycle is exactly the condition under which refrigerant efficiency degrades fastest — and where small inefficiencies scale into large, permanent electricity costs.
Cooling is 30–40% of total load
After the IT load itself, cooling is the single largest consumer of power in most facilities — and the largest controllable one.
24/7/365 operation accelerates degradation
Compressors that never rest see refrigerant electron balance drift continuously, so COP quietly slips below spec over months and years.
PUE and ESG pressure is rising
Operators are under constant pressure to lower Power Usage Effectiveness and report carbon reductions to customers and regulators.
HOW ECO PULSAR APPLIES
Restoring refrigerant efficiency in your existing system
Eco Pulsar treats the refrigerant inside your existing CRAC, CRAH and chiller circuits using ERT (Electron Replace Technology) — restoring the molecular electron balance that degrades under continuous operation.
Because the unit installs alongside existing equipment and requires no cutting, recharging, or shutdown, it is compatible with uptime-critical, concurrently-maintainable environments. Nothing in the cooling path is modified.
As refrigerant efficiency is restored, compressors deliver the same heat removal for less electrical work — directly lowering cooling energy and improving PUE.
How ERT worksEXPECTED RESULTS
EstimatedWhat savings can a data center expect?
Eco Pulsar is already deployed in data-center environments within its 200+ site installed base. Continuous-duty cooling is where ERT tends to perform at the upper end of its range, though exact savings depend on plant age and baseline efficiency.
15–20%
Estimated cooling-energy reduction
Estimated range based on typical ERT performance on continuous-duty cooling systems and Eco Pulsar's verified 15–20% results in comparable applications. Not a site-specific measurement — a free on-site verification test establishes your actual baseline before any commitment.
WHY IT FITS DATA CENTERS
No downtime to install
Fits concurrently-maintainable and uptime-critical facilities.
Lower PUE
Less cooling energy for the same IT load improves your efficiency ratio.
Works with existing plant
Complements CRAC, CRAH and chilled-water systems — no rip-and-replace.
Reportable carbon reduction
Lower kWh translates directly into ESG and Scope 2 reductions.
See what Eco Pulsar can save your facility
We start with a free on-site verification test — measuring your baseline, installing a trial unit, and giving you a full before/after comparison before any commitment.